Phone 09 834 0212

Desic Diamond DRY Polishing Pads 7 Grits And 100mm M14 Backing Pad

Desic Diamond DRY Polishing Pads 7 Grits And 100mm M14 Backing Pad


 

$129.00

(Incl. GST)
T30770
In stock
+
Add to wish list

Description

LET US KNOW IF YOU WANT TO MIX AND MATCH THE 7 POLISHING PADS, WE CAN MAKE SETS TO SUIT YOUR REQUIREMENTS.

These diamond polishing pads can be used with any angle grinder to polish a range of very hard materials into beautiful shiny pieces such as kitchen benchtops, concrete hearths, garden art, custom poured concrete vanities etc.

There are 7 velcro backed polishing pads in the set which simply stick to the included velcro backing pad that attaches to your angle grinder. The best control is achieved when using a variable speed angle grinder. The backing pad is flexible so it makes it easy to polish without gouging.

They are designed to be used dry which in most situations is a lot easier especially if a concrete hearth or benchtop has been poured in place and water would make a huge mess. However, if necessary they can also be used wet.

WET OR DRY POLISHING?
Wet polishing eliminates harmful dust but makes a messy slurry that can be difficult to clean up. Dry polishing is convenient but the dust needs to be managed. Either method gives the same finished result. So which is better for you depends on the situation.

USE ON THE FOLLOWING MATERIALS
Concrete, marble, stone, engineered benchtops, terrazzo, jade, greenstone, glass, porcelain, quartz etc.

SPECIFICATIONS
Diamond polishing pads - 100mm (4") diameter, 2mm thick, velcro backing
Backing pad - 100mm (4") diameter M14 thread, velcro backing*

Recommended operating speed 9,500rpm

* We can supply backing pads with M10 thread, just let us know when ordering.

SET INCLUDES
1 x 50 grit - start polishing with this one
1 x 100 grit - then use this one
1 x 200 grit - then use this one
1 x 400 grit - then use this one
1 x 800 grit - then use this one
1 x 1500 grit - then use this one
1 x 3000 grit - finish with this one
1 x 100mm M14 backing pad*

NOTES
Most 100mm angle grinders in New Zealand have a 14mm (M14) spindle thread but check yours just in case it's a 5/8" (which we can supply on special order).
- For best results and to extend product life, use with a variable speed angle grinder. 

SAFETY
Dry polishing must be used with effective dust extraction equipment and respirators.

* The backing pad foam colour supplied may be different to the one in the photo.